Overnight delays expected on US 60 between Superior and Globe/Miami July 27-29

Motorists traveling on US 60 between Superior and Globe/Miami should allow extra travel time and plan for short delays overnight Monday through Wednesday, July 27-29 while construction crews remove loose rocks as part of the new Oak Flat passing lane project (milepost 231-233).

Work hours will be from 9 p.m. to 4 a.m. Monday through Wednesday nightly and all traffic restrictions will be lifted at approximately 4 a.m. on Thursday, July 30.

A pilot car will be used to guide traffic through the construction zone as intermittent closures are necessary to complete the work. Motorists should anticipate delays of up to 15 minutes. The speed limit will be reduced through the construction zone and drivers are asked to use caution and be alert for construction equipment and personnel.

ADOT works to inform the public about planned highway restrictions, but there is a possibility that unscheduled closures or restrictions may occur. Weather can also affect a project schedule. To stay up-to-date with the latest highway conditions visit the construction website at azdot.gov/us60oakflat or visit the ADOT Traveler Information Center at www.az511.gov.

US 89 restrictions starting Tuesday south of Gray Mountain for start of roadway widening and passing lane project

FLAGSTAFF/CAMERON — Restrictions for both north- and southbound travel on US 89 just south of Gray Mountain between Flagstaff and Cameron (milepost 452 to 455) will begin daily, starting on Tuesday (July 21) to Saturday (July 25) from 6 a.m. to 6 p.m. The restriction will accommodate installation of temporary concrete barriers and shoulder work in preparation for a $2.8 million roadway improvement project.

The improvement project includes widening of US 89 through the project area, installation of a new passing lane for northbound travel, drainage extensions and new pavement resurfacing. This project is scheduled to be constructed in two phases, with the first phase to be completed mid-December, 2015.

During this phase of construction, lane restrictions can be anticipated, however one lane of travel in both directions will be allowed during most of the construction schedule. Please observe reduced speed limits and allow for extra travel time while traveling through the work zone.

US 89 narrowed to one lane between Arizona/Utah border and south of US 89A Junction at Bitter Springs beginning Tuesday

US 89 will be narrowed to one lane with alternating access for both directions between the Arizona/Utah state line to just south of the Bitter Springs Junction at US 89A (milepost 556 to 517) from Tuesday (July 21) to Friday (July 22) from 7 a.m. to 5 p.m. The restriction is required to allow Arizona Department of Transportation crews to install pavement markers on the roadway.

During installation, delays of up to 15 minutes can be anticipated. A pilot car will allow for alternating travel through the work zone. Please allow for extra travel time during construction and be alert while traveling through the work zone.

Bridge work complete on SR 260 east of Payson

The Arizona Department of Transportation has completed a bridge rehabilitation project on State Route 260, approximately 20 miles east of Payson and will remove all existing traffic control devices today on Monday, July 20.

Last year, ADOT upgraded five eastbound bridge approaches on State Route 260 and then returned in the spring to replace and repave three westbound bridge approaches between mileposts 272-277.

The $2.9 million improvement project included the removal of the existing bridge approaches and departure slabs, repaving the roadway at the bridge approaches, guardrail reconstruction and the replacement of existing pavement markings.

Crews will repair a dip in the roadway on SR 260 eastbound at milepost 271 starting on Monday, August 3 which will require a single lane restriction through September 11.

ADOT enhances security of driver license application process

PHOENIX — The Arizona Department of Transportation is taking an active role in curbing identity theft and fraud by implementing facial recognition technology in the application process for state-issued credentials.

An applicant for a new or duplicate driver license or state ID card at an ADOT Motor Vehicle Division or Authorized Third Party office will have their photo taken at the beginning of the process. Facial recognition during the “Photo First” review process occurs seamlessly and without delay as the customer continues through the application process.

In 2012, ADOT Motor Vehicle Division implemented a Photo First approach to aid in the detection of and prevention of fraud, forgery and identity theft. In 2014, ADOT Motor Vehicle Division implemented Central Credential Issuance, eliminating credentials being issued at the MVD or Authorized Third Party offices. Both processes have contributed to a more comprehensive review of applications along with providing more time to identify possible fraudulent submissions.

One of the best screening formats in the detection of identity theft, attempted fraud or forgery in the application process has always been the ADOT Motor Vehicle Division customer service representatives who initially review all documents submitted in the application packet. During this initial screening process of the application packet by ADOT employees, possible file errors or fraudulent submissions are detected.

“Facial recognition technology supports the commitment by ADOT to protect the privacy of its customers, and to maintain the integrity and accuracy of the credential issuance process,” said ADOT Director John Halikowski. “This technology enables us to fight against fraud and identity theft.”

The technology provides an effective screening method to identify errors in customer records in the state driver license database and to prevent fraudulent attempts to obtain an Arizona driver license or identification card. It also allows ADOT to develop the new federally compliant Voluntary Travel ID according to the requirements outlined in the federal REAL ID Act of 2005.

When a credential application record generates an alert resulting from the facial recognition technology, the system will automatically perform an additional review of the record to identify and correct any possible file errors. If the system verifies it is not a file error, the record will then undergo a comprehensive review by personnel in the ADOT Office of the Inspector General.

“This technology allows us to take a proactive approach to protecting people’s identities and stopping fraud,” said ADOT Assistant Director Terry Conner, who leads the Enforcement and Compliance Division. “Our detectives are already working investigations after reviewing reliable information provided by the system.”

US 180 lane restrictions to begin early Monday

US 180 will have lane restrictions for east- and westbound travel beginning Monday (July 20) and continue daily through the week until Friday (July 25) for roadway striping.

The work will be performed from Columbus Avenue to Bader Road (milepost 216 to 224) from 3 a.m. to noon daily.

Please allow for extra travel time while in construction area and exercise caution while driving in the work zone.

I-40 restrictions between Williams and Ashfork begin Monday

Westbound Interstate 40 will be narrowed to one lane at Exit 149 (County Line) milepost 148 for bridge work.

The lane restriction will begin Monday (July 20) to Thurs (July 23) from 6 a.m. to 6 p.m. daily.

Please allow for extra travel time while in construction area and exercise caution while driving in the work zone.

I-40 bridge overpass at Twin Arrow Road (exit 219) reduced to one lane at times beginning Monday morning (Jul. 20)

PHOENIX — Geotechnical work on the Interstate 40 overpass at the Twin Arrow Road traffic-interchange will begin on Monday (Jul. 20) and continue daily until Wednesday (Jul. 22). Please use caution while the following restrictions are in place:

  • I-40 bridge overpass at Twin Arrows Road (exit 219), toward the Twin Arrows Casino, reduced to one lane at times daily from 7 a.m. to 4 p.m. Monday through Wednesday (Jul.20-22). Flaggers will be present during restrictions to guide traffic through the work zone.

Please allow extra travel time and to be prepared to merge safely when approaching the work zone.

A geotechnical investigation is designed to provide engineers with data on conditions below the surface, helping to refine construction plans and processes. The Twin Arrows TI project is scheduled to begin in 2016.

Widening project complete on SR 89 between Prescott and Chino Valley

Motorists traveling between Prescott and Chino Valley on State Route 89 (mileposts 320-325) now have a four-lane divided highway along a five-mile segment between Road 4 South in Chino Valley and Deep Well Ranch Road in Prescott.

Crews completed the final paving earlier this week and fully opened the roadway yesterday, July 15.

For the next six weeks, drivers can expect intermittent lane restrictions between 6 a.m. and 5 p.m. Monday through Friday until August 31 as crews do miscellaneous work and clean up on the project.

I-40 westbound travel reduced to one lane and on-ramp closure for County Line (exit 148) just east of Ash Fork

ASH FORK — Westbound travel on Interstate 40 (I-40) at the County Line traffic interchange (Exit 148) just east of Ash Fork is reduced to one-lane of travel and will be in place continuously including nights and weekends until late July while repairs are underway. Construction within the work-zone will be active during daylight hours; however the restrictions will be in place both day and nighttime hours.

The westbound on-ramp at the County Line (Exit 148) will also be closed while work is being performed at the interchange. The recommended detour is to exit at the Monte Carlo traffic interchange (Exit 149) then cross over for westbound travel.

ADOT advises the public to allow for extra travel time while work is being performed and to observe reduced speeds in the area.